Yengst says the first cone is 36 inches long, but that doesn't fit with the overall length and the half‑angles. Is that a mistake? And does the total length include the RCS ball at the tail? Looking for verified numbers.
No, that can't be right. Alpha Draco is 312-313"/26ft long, 31" in diameter, and the cone section alone is 156"/13ft long. It's a really freaking big thing!Could be one mixed up dimensions with Alpha Draco. Yengst talks about both of them as I recall.
Jeez, that's only a little shorter than Alpha Draco! 23ft instead of 26ft.Pg 167 from Bruelle. [...] This is BGRV.
Brulle's drawing is almost completely different from Yengst's. The overall length, first-cone half-angle, number of tail control fins, and the degree of tail-fin flare and contraction are all different — and it doesn't match any known BGRV photos, including the museum images. Brulle is clearly describing an unknown version of the 122 vehicle.Pg 167 from Bruelle. There are two different programs being discussed in both documents: Alpha Draco and BGRV. This is BGRV. Atlas is 10' in dia.
Where does Yengst even give dimensions for BGRV? BGRV and 122 are two different vehicles.Brulle's drawing is almost completely different from Yengst's. The overall length, first-cone half-angle, number of tail control fins, and the degree of tail-fin flare and contraction are all different — and it doesn't match any known BGRV photos, including the museum images. Brulle is clearly describing an unknown version of the 122 vehicle.
Yengst of course gave BGRV parameters — including the overall lengthWhere does Yengst even give dimensions for BGRV? BGRV and 122 are two different vehicles.
BGRV is the one on Atlas. 122 is the one in post #3 up the page.